Tascam FW-1082 User Manual download pdf (Page 25)

4 – Control Surface Modes and Operation

TASCAM FW-1082 Owner’s Manual 25

Setting all monitor mix levels to 0 dB

(unity gain) Press and hold the SHIFT key and

then press the

F4 / MAST 0dB key.

Setting all mixer parameters to default

values Press and hold the SHIFT key and then press

the

F3 key.

Adjusting the fader sensitivity This adjusts

the touch sensitivity of all faders.

• Press and hold the

SHIFT key and adjust the sensi-

tivity with the

EQ GAIN encoder.

•The

REC and SEL indicators are used to show the

level of sensitivity (further to the left indicating less

sensitivity, and further right indicating more

sensitivity).

Setting Input levels

As previously stated, the MON MIX mode can be very

useful for recording live tracks into a DAW applica-

tion. Here’s a typical scenario for recording and over-

dubbing using

MON MIX mode:

• Connect your analog and/or digital source(s) to the

FW-1082’s inputs.

•In

COMPUTER control mode, arm your DAW tracks

for recording and meter the input level to those

tracks using the DAW’s level meters.

• Select

MON MIX to access the monitor mixer con-

trol surface mode.

• Press the

F2 INPUTS key to monitor the inputs

without hearing your existing DAW tracks.

• Solo an input channel by pressing that channel’s

SOLO key.

• Adjust the channel’s

TRIM pot (if it is an analog

input) or the digital source (if it is a digital input)

until the input meter in your DAW shows a level

that is hot, but not clipping.

• Repeat this procedure for all active input channels.

Once you’re done setting up levels, you can return to

COMPUTER control mode and begin recording.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Comments to this Manuals

No comments

Tascam FW-1082 User Manual Page 25

Comments to this Manuals