Tascam FW-1884 User Manual download pdf (Page 27)

4 – Control Surface Modes and Operation

TASCAM FW-1884 Owner’s Manual 27

4.2.3 Programming Encoders

The eight channel encoders, as well as the three EQ

encoders, can all be reprogrammed. To display the pro-

grammed message for an encoder, just turn it slightly.

You will see a display something like this:

To change the MIDI output(s): Checking or un-

checking the four Port boxes will select or de-select the

corresponding MIDI output. MIDI messages gener-

ated by the key that you’re programming will be sent to

each port whose associated box is checked.

To change the MIDI channel: Use the up and down

arrows of the Channel indicator box to change the

MIDI channel. Alternatively, you can type in a MIDI

channel number from 1 through 16.

To change the MIDI controller number: Use the up

and down arrows of the Controller indicator box to

change the MIDI controller number. Alternatively, you

can type in a MIDI controller number from 0 through

127.

Encoders send continuous controller messages only, so

the NOTE ON/OFF and TOGGLED CONTROL-

LER options on the FW-1884’s control panel are

grayed out.

4.2.4 Programming Faders

The eight channel faders, as well as the master fader,

can all be reprogrammed. To display the programmed

message for a fader, simply touch the fader. The display

should look something like this:

(When you touch the master fader, you will see that its

programming information does not include bank

information since it is a single, global control that is

active in all banks.)

To change the MIDI output(s): Checking or un-

checking the four Port boxes will select or de-select the

corresponding MIDI output. MIDI messages gener-

ated by the key that you’re programming will be sent to

each port whose associated box is checked.

To change the MIDI channel: Use the up and down

arrows of the Channel indicator box to change the

MIDI channel. Alternatively, you can type in a MIDI

channel number from 1 through 16.

To change the MIDI controller number: Use the up

and down arrows of the Controller indicator box to

change the MIDI controller number. Alternatively, you

can type in a MIDI controller number from 0 through

127.

Faders can only be MIDI controllers, and the NOTE

ON/OFF and TOGGLED CONTROLLER options

on the FW-1884’s control panel are greyed out.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 41 42

Comments to this Manuals

No comments

Tascam FW-1884 User Manual Page 27

Comments to this Manuals